Search for a command to run...
This is the sixth post in the µFerris & Xiao BSP series, where we build a Board Support Package from scratch, one peripheral at a time. In the previous post, we added the buzzer using PWM. This post a
This is the fifth post in the µFerris & Xiao BSP series, where we build a Board Support Package from scratch, one peripheral at a time. Series Past Posts Device Setup & Getting Started Getting star
This is the fourth post in the µFerris & Xiao BSP series, where we build a Board Support Package from scratch, one peripheral at a time. In the previous post, we set up the template. This post is the
This is the third post in the µFerris & Xiao BSP series, where we build a Board Support Package from scratch, one peripheral at a time. In the previous post we met the board, wired up the toolchain, a
This is the second post in the µFerris & Xiao BSP series. If you haven't yet, start with Getting Started with µFerris & Xiao where we assembled the board, set up the toolchain, and blinked an LED. Thi
An all-in-one open-source learner board for embedded Rust, built around the Seeed Studio XIAO platform.
Go from a XIAO board to a ready-to-build bare-metal Rust project with a single command.
A community giveaway program by The Embedded Rustacean × Seeed Studio to grow the embedded Rust ecosystem
Introduction Another year comes to an end; as always, it is an opportunity to reflect on the achievements of the past year and look forward to the next. It's been over 3.5 years since I embarked on my embedded Rust journey, and it only gets more exci...
